Elegance Electric Only Thermostatic Heating Element 300W
Abacus Elegance Electric only element Thermostatic 300w Silver
Allows the user to thermostatically control the room ambient temperature
Independant on/off switch
Temperature increase/decrease dial
2 hour override button
The thermostatic element has an on/off button and a thermostatic dial to enable you to control the
room temperature. It is also available in a silver finish to complement chrome or polished stainless steel
Note. IPX4 rated. Suitable for installation into IEE Zone 2 or 3.
The 2 hour override enables you to override normal mode and make the radiator work continually for two hours (ie.
Select this mode if you want to dry clothes).
1. Press button 2H continuously until the led starts blinking and then release it.
2. The system goes to heating mode for two hourís, you may interrupt the cycle at any time by
pressing button 2H again.
Where a separate heat source exists in a room i.e. under tile electric heating, it is important that either a regulator
element or a standard element with wall controller is used and not a thermostatic element. This is due to the fact
that the secondary heat source may cause a thermostatically controlled element to cut out prematurely.